A8 between Belfast And Larne
Northern Ireland: The new A8 (Larne Line) Duelling Project is under construction by a consortium of companies, government departments and is funded by various means including- Lagan Construction, Ferrovial Agroman and Costain Ltd. It is co-financed by the European Union Trans-European Transport Network (TENT), Northern Ireland Assembly and the Irish Government.
We would assume under the auspicious of the Department for Regional Development – Transportni.
We have just had it confirmed that the vehicle restraint system to be used throughout the centre reserve of the A8 project will generally be the wire rope type.
At Right To Ride we have major concerns about these Vehicle Restraint Systems (VRS), as do the majority of riders around the world i.e. Ireland, England, Scotland and Wales and in the rest of Europe as well as America, Australia and New Zealand, in fact anywhere in the world where these systems are installed with motorcycle – scooter or trike riders present.
As with Sweden and England, various reports from riders organisations conclude that there appears to be no consideration taken for the possible fatal interaction with riders in the case of a collision with these “killer” wire rope barriers.
Why are these barriers with their multiple exposed rigid – for a riders body to hit – posts still fitted on our roads when other countries have banned them from being fitted such as Norway, Denmark and the Netherlands?
The answer is the European standards (CEN) allow this type of system to be fitted on all of our roads, after testing with other vehicles but not in consideration with motorcycles nor with riders (crash test dummies).
CEN approve standards and pass the criteria laid down in the testing for the standard.
Design Manual For Roads And Bridges Requirement for Road Restraint Systems
This is further compounded in the document “Design Manual For Roads And Bridges Requirement for Road Restraint Systems”.
The document describes the procedures to be followed by the various parties involved in the design and provision of various types of Road Restraint Systems and also introduces a risk based framework to support designers in making optimal design choices at specific sites.
The document also known as the – Road Restraints Standard TD19/06 – is used by – The Highways Agency – Transport Scotland – Welsh Assembly Government Llywodraeth Cynulliad Cymru and our own Department For Regional Development Northern Ireland
As regards motorcyclists the document states:
- “The Road Restraint Risk Assessment Process – 2.23 The RRRAP is not capable, at present, of assessing the risk to motorcyclists. Factors that must be considered in respect of motorcyclists are outlined in Chapter 3 Paragraphs 3.41 and 3.42.”
- “2.26 The RRRAP will highlight if the risk is ‘broadly acceptable’, ‘tolerable’, or ‘unacceptable’.”
Now Chapter 3 Paragraphs 3.41 and 3.42. says:
- 3.41 At sites identified, e.g. through accident records, to be high risk to powered two-wheel vehicles, such as tight external bends, consideration must be given to the form of VRS chosen to minimise the risk to this category of driver. Any special requirements must be stated in the contract.
- 3.42 At such high risk sites, it is recommended to use an ‘add on’ motorcycle protection system to post and rail type safety barriers to minimise the risk of injury to motorcyclists. The Design Organisation must check with the safety barrier manufacturer that any such proposed protection will not invalidate the tests on the safety barrier. Such ‘add on’ products must be approved by the Overseeing Organisation and be compatible with the safety barrier to which it is being attached as these products are not included within BS EN 1317.
These sections of the document have been quoted in response to the A11 Riders Action Group.
However in our mind and our interpretation is that these are quoted out of context because what has been quoted is identifying sites at high risk, with the one example of tight external bends.
In context and for the overall fitting of wire rope barriers (Vehicle Restraint Systems -VRS) as regards motorcyclists, TD19/06 quite plainly states that the Road Restraint Risk Assessment Process – RRRAP – is not capable, at present, of assessing the risk to motorcyclists.
Therefore these systems are being fitted without consideration for the risk regarding injury and death to motorcyclists – in fact there appears to be no consideration to other vehicles or non motorised users (i.e. behind the VRS installation) or how a motorcycle reacts when striking the wire rope barrier.
Even if there is the best standard in the world for other vehicles they are not assessed/tested for motorcycles.
A Plethora Of Documents
In our Right To Ride Virtual Research Library, the Crash Barrier page has a plethora documents and videos that identify the dangers and the risks of these wire rope barriers. In the eyes of our roads authorities how many people can be so wrong over so many years?
Although in Northern Ireland we are not aware of any impacts by motorcyclists with these wire rope barriers, however the more of them that are fitted the greater the risk that an impact will happen.
Perhaps it is time for that factor to be considered more in-depth, before there are any further instalments of wire rope barriers.
What is clear at Right To Right is that when Ministers, politicians and government gear up to announce that projects will result in improved safety for traffic or there will be a positive finacial impact on Northern Ireland, they have all forgotten about one mode of transport and that is the motorcycle – the scooter and their riders and the ultimate responsibility lies with these people
Therefore these systems are being fitted without consideration for the risk regarding injury and death to motorcyclists.
As a rider what is your opinion of wire rope barriers?
Guardrails Kill Motorcyclists
Sweden: SMC (Sveriges MotorCyklister) the Swedish motorcyclists association have stated that they are convinced that this summer’s low death toll in motorcycle accidents could have been even lower if the design of the road environment was not so deadly for riders – vulnerable road users.
SMC states that, “Six of the 22 people who died in a motorcycle collision collided with a crash barrier.”
The proportion of motorcyclists killed in guard rail accidents is the highest ever, not only in Sweden but is also higher in comparison to international comparison proportions.
SMC further states that these, “Dangerous barriers cost not only lives, they cost society billions.”
An in-depth study by the Swedish Transport Administration of single-vehicle fatalities found that every third motorcyclist was killed in a collision was with a post or railing.
SMC say that there may several reasons for this.
They speculate that more and more roads are fitted with centre and side rails which increase the risk of injury to motorcyclists. There is no requirement that the rails used are safe for other road users other than those traveling in cars.
Structurally the barriers may be very close to the road, with side rails replacing forgiving roadside areas, i.e. ditches without poles, stones and/or other solid objects.
Five out of six fatal accidents this year occurred on the TENT-roads with the highest safety demands and thus also higher speed limits (100-120 km/h).
At the same time this is where most fatal motorcycle accidents occur.
In the last six years, 15 out of 25 fatal motorcycle accidents where the rider crashed into a barrier happened on a TENT-road.
SMC calls for a new way of thinking: Smoother median and side barriers without unprotected poles are needed.
The barriers must be installed further away from the road than what is allowed today.
It is obvious that a forgiving roadside should be used where it is possible, instead of side barriers.
Alarm Bell To Road Operators
SMC presumes that the high share of fatal motorcycle accidents with barriers, and the high amount on the TENT-roads, is an alarm bell to all road operators.
Jesper Christensen, General Secretary of SMC, states, “As a representative for Swedish riders, I am horrified with the high number of motorcycle accidents. Everyone is aware of the fact that barriers and motorcyclists is an unhealthy combination, yet very little is done in order to make the road environment safer for motorcyclists when it comes to barriers.”
According to the calculation model of the Swedish Transport Administration, the cost to society for killed and severely injured motorcyclists in crash barrier accidents during the last six years has passed one billion Swedish kronas* (1,255,275,000).
Swedish society would save not only lives and life long suffering, but also money with another way of planning and building the road environment.
We are aware that 5.5 billion Swedish kronas are budgeted in order to install more barriers on Swedish roads in the coming years.
We can only hope that this amount is spent wisely and that safer barriers are used and installed where they do not pose a danger to the lives of motorcyclists.
* 1 Euro = 9,23 SEK.
A11 Riders Action Group
England: Meanwhile as we have previously reported, the planned demonstration by the newly formed A11 Riders Action Group took place on Sunday 14th September 2014.
The ultimate aim of the group is to ban the use of Wire Rope Barrier Vehicle Restraint Systems, which are seen by motorcyclists as the most dangerous type of system.
The demo ride concentrated on wire rope barriers which are in the process of being fitted on the A11 project between Thetford and Barton Mills in Norfolk – England.
The protest saw more than two hundred riders take part.
This action group also has a petition on the Government petition website and has been in dialogue with the Highways Agency, MP, MEPS and ministers.
The organisers of the ride state “With the details from today’s ride these will be the questions I will be putting forward:
- At what point will the DfT (Department for Transport) and Highways Agency prove that these barriers are safe for motorcycles by carrying out tests using a single track vehicle?
- It has been stated a full safety audit had been carried out for this new stretch of road, was a Motorcycle champion included in that audit, if so who?
- Can we see the final draft of the audit?
- Will you please ask The Honourable Secretary of State for the Department of Transport, in the reply he sent you from the Director of the Highways Agency, why are there direct contradictions to statements made for and by the Highways Agency?”
The organisers ask riders to ask these questions, or their own of their elected MPs and MEPs.
The A11 Riders Action Group finally added, “Today’s ride will show that people are unhappy, the campaign will grow. Remember this is about Riders Rights, about the Government and it’s agency carry out the duty of care to all, especially vulnerable road users.”
Links & Information
Right To Ride – Crash Barriers Wired Up – Click Here
Right To Ride – Virtual Research Library – Crash Barriers – Click Here
SMC – On Facebook
www.svmc.se
A11 Riders Action Group – On Facebook
Design Manual For Roads And Bridges – pdf – Click Here
CEN/TC 226/WG 1 – Crash barriers, safety fences, guard rails and bridge parapets – Click Here
These Crash barrier designs are definitely inferior to the Armco systems If a truck or something large hits one of these low designs it will bind on the tension hawsers and quite probably flip or roll into oncoming traffic.
As to a Motorcyclist or budget car hitting these Hawser restraint systems someone better get their chequebook to cover liability …..
Because ….whoever approves these designs for installation better be prepared to stand for corporate manslaughter !!!